CDS Tactical Products​
  • Store
  • Blog
  • Product Registration
  • Contact
  • Blog

Remington Single Point Sling Attachment Installation Procedure

12/6/2015

0 Comments

 
Thank you for purchasing our Remington ambidextrous Single Point Sling Attachment. Please read the instructions below prior to installation.
Prior to installation make sure the firearm is unloaded, and that you follow all standard firearms safe handling procedures.
Picture
Single Point Sling Attachment (SPSA) shown out of packaging.
Picture
1) Unscrew removable eye and remove (1) o-ring from shaft.
Picture
2) Locate rear trigger housing pin, direct above trigger. The SPSA will replace this pin.
Picture
3) Align shaft of SPSA with housing pin.
Picture
Picture
4) Push SPSA through, ejecting housing pin.

Picture
Picture
5) Place o-ring over shaft of SPSA. The o-ring is there to protect the finish of your firearm.
Picture

Picture
6) Screw on eye finger tight.
Picture
7) Use (2) tools/items that will pass through the eyes and tighten 1/8 turn. CAUTION! DO NOT OVER-TIGHTEN.
0 Comments

Your comment will be posted after it is approved.


Leave a Reply.

CDS Tactical Products
​51 Ralston St. Suite 11

Keene, NH 03431



team@cdstactical.com
Copyright © 2017