CDS Tactical Products​
  • Store
  • Blog
  • Product Registration
  • Contact
  • Blog

Kel-Tec KSG Grip Wrap Installation Instructions

11/21/2015

0 Comments

 
Thank you for purchasing CDS Tactical Products new Gen 2 Kel-Tec KSG Grip Wrap. Please read the instructions below prior to application.
Prior to installation make sure the firearm is unloaded, and that you follow all standard firearms safe handling procedures.
Picture
Picture
1) Clean wrap installation areas with a lint free cloth and a cleaner that will not leave a residue behind. An alcohol wipe works great for this. 

2) It is recommended that you try the fit of the cut out wrap to the area it will be applied with the backer still affixed.
Picture
Picture
3) Gently warm the area of the firearm where you will be applying the wrap to. This will allow the wrap to conform to irregular surfaces on the firearm. Surfaces only need to be warmed.  

Picture
Picture
Picture
4) ​Fore-grips:
Start
by placing the wrap along the base of the rail and smooth out and up using first light pressure re-position if needed. Repeat on opposite side.


Picture
Picture
Picture
Picture
Picture
Picture
Picture
.5) Back-Strap:
Starting at the base of the grip, use the alignment notch on the wrap to center it up along the split line on the grip. Lightly work towards the magazine selector being careful to align notch in wrap with stock parting line and smooth out using first light and then firm pressure. Re-position if needed.
​Note: Notches are shown highlighted in picture above with yellow circles.


Picture
Picture
Picture
Picture
Picture
Picture
5) Main wrap panel:
Starting at the base of the grip, use the alignment notch on the wrap to center it up along the split line on the grip. Lightly work towards the trigger guard being careful to align notch in wrap with stock parting line and smooth out using first light and then firm pressure. Wrap one side over the grip first keeping an eye on the cutout for the take down pins then wrap opposite side. Re-position if needed. ​Note: Notches are shown highlighted in picture above with yellow circles.


Picture
Picture
Picture
Picture
Picture
6) Use hair dryer to gently warm applied wrap and use firm pressure to allow wrap to conform to any irregular surfaces on the firearm. 

Enjoy you new wrap!!

0 Comments

Your comment will be posted after it is approved.


Leave a Reply.

CDS Tactical Products
​51 Ralston St. Suite 11

Keene, NH 03431



team@cdstactical.com
Copyright © 2017