CDS Tactical Products​
  • Store
  • Blog
  • Product Registration
  • Contact
  • Blog

RFB Single Point Sling Installation Instructions

11/18/2020

0 Comments

 

Thank you for purchasing our Remington ambidextrous Single Point Sling Attachment. Please read the through the entire instructions below prior to installation, failure to do so can result in unsatisfactory results.

Prior to installation make sure the firearm is unloaded, and that you follow all standard firearms safe handling procedures.
The Sling attachment point is designed to replace your existing hammer pivot pin
Picture
To make assembly easier push the rear assembly pins to allow the magwell area of the rifle to pivot downward. Once this is done remove your hammer pivot pin using a 3/32" allen wrench and pull out the pin. Put pin and screws aside in case you ever want to revert back to the factory pin assembly.
Picture
Slide the sling attachment point shaft through the hole in the magwell from the desired sling attachment side and add Loctite Threadlocker (included) onto the keeper threads and screw the SAP eye onto the shaft and tighten.
Rotate the magwell up (slight pressure on the buttstock toward the muzzle may help with hole alignment)depress the 2 assembly pins fully into place.
Picture
Enjoy your new sling attachment point. Please feel free to contact us with any comments, questions or concerns and thankyou for your business
0 Comments

Your comment will be posted after it is approved.


Leave a Reply.

CDS Tactical Products
​51 Ralston St. Suite 11

Keene, NH 03431



team@cdstactical.com
Copyright © 2017